Config Mikrotik R2: Difference between revisions

Revision as of 03:01, 11 April 2026

System - Identity

ganti nam dengan R2

Bridge - Klik tombol + Trus Klik Ok

Kemudian tab pada menu port trus klik tombol +, Masukkan port ether2 dan ether3 pada Brdige

ip-addess-add

address=10.200.200.2/30 - interface=ether1

address=172.17.200.200.1/28 - interface=bridge1

ip - dns - server = 8.8.8.8 - centang allow-remote-request

ip - dhcp-server - DHCP setup

server interface pilih bridge1 kemudian klik next trus dampek selesai

ip - firewal - tab NAT - add chain=srcnat - out-interface=ether1 - tab Action - action=masquerade

ip - route - add - Dst-addres=0.0.0.0/0 - gateway=10.200.200.1

trus add route lagi

dst-address=172.16.200.0/29 - gateway=10.200.200.1

@@ Line 25: / Line 25: @@
 === Setting ip address ===
-<code>ip-addess-add address 10.200.200.2/30 interface ether1</code>
+<code>ip-addess-add</code>
-[[File:Address_ether_1.png|left|frameless]]
-Ulangi langkah diatas pada interface bridge dengan ip address 172.17.200.200.1/28
-[[File:Ether bridge.png|left|border]]
+<code>address=10.200.200.2/30 - interface=ether1</code>
+<code>address=172.17.200.200.1/28 - interface=bridge1</code>
 === Setting DNS server ===
-<code>ip - dns - server</code>
+<code>ip - dns - server = 8.8.8.8 - centang allow-remote-request</code>
-masukkan dns 8.8.8.8 trus centang pada allow remote request
-[[File:Dns server.png|left|thumb]]
 === Setting DHCP Server ===
 <code>ip - dhcp-server - DHCP setup</code>
 server interface pilih bridge1 kemudian klik next trus dampek selesai
-[[File:DHCP server.png|left|frameless]]
 === Setting NAT ===
 <code>ip - firewal - tab NAT - add chain=srcnat - out-interface=ether1 - tab Action - action=masquerade</code>
-[[File:Nat.png|left|thumb]]
 === Setting Route ===
 <code>ip - route - add - Dst-addres=0.0.0.0/0 - gateway=10.200.200.1</code>
-[[File:Route1.png|left|thumb]]
 trus  add route lagi
 <code>dst-address=172.16.200.0/29 - gateway=10.200.200.1</code>